HOW TO MAKE A TOY HELICOPTER

Hi there, welcome to the channel Brainergiser We are going to make this fighter helicopter model from easily available items at home first collect a 600 ml cold drinks bottle carefully cut the neck part of the bottle using a knife cut the backside too we are going to keep a triangular part at the bottom part cut the blue part out and at the top section will divide into 4 stripes use a marker pen to mark the bottom part now with a scissor cut the window section out This is how the bottom part will look like and there are 4 stripes on top part bend each one stripe downwards hold all of them together and straight cut to take the extra part out This is how the body section of the helicopter will look like next item you need is black chart paper roll it to make a long , 1 cm in die paper tube stick the paper with cello tape and glue cut it to have approx. 16 cm long tube now make 3 narrow, 10 to 12 cm long tubes each one approx. 0. 5 cm in dipstick all on another bigger black paper with glue and roll all together once dried cut it into two pieces get a small rubber ball stick it with glue at the neck part glue all the stripes together now stick the long tube with the body section use enough glue to make the joint strong cut few more black paper to make the tail wings or stabilizer do it the way you want to make it, and I want to show that there is no specific or exact design for it glue the barrel gun both side of the body stick two small wings cut 3 small wheels from a cardboard and going to paint them in black color using glue and tooth-prick stick them with the helicopter one at the back color and other two wheels located at the front side this is how it will look like now paint the copter in black using fabric color this is how it should look like after painting is done I did not color the front glass/window area. take a long black chart paper and cut the main rotor blade from it stick two of them to have a thicker blade stick a toothpick at one end now you need a small bottle cap and a small plastic pipe make a hole at the cap and pass the pipe through it glue the blades with the plastic pipe and after that you may need to use extra glue take a copper wire and make a loop at one end make one hole on top of the copter and what we do next is need to pass the wire through it now pass the tube of the rotor blade through the wire loop the wire at top and cut extra wire out. Thus the model is ready.  the rotor blade can move freely if you blow some extra air you can enhance the model by connecting one small dc motor with the rotor blade another motor with a tail rotor blade use ether battery to power the motor and hide the battery inside the body section thanks for watching the video make your own model in next video we will try to make it fly bye